Administrator Guide

Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage
Information
To accept 4-byte formats before entering a 4 byte AS Number, configure your
system. If the number parameter is the same as the AS number used in the router
bgp
command, the remote AS entry in the neighbor is considered an internal BGP
peer entry.
This command creates a peer and the newly created peer is disabled (Shutdown).
This command automatically restarts the neighbor session for the configuration to
take effect.
Related
Commands
router bgp — enters ROUTER BGP mode and configures routes in an AS.
bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-
name
} remove-private-as command.
Parameters
ip-address Enter the IP address of the neighbor to remove the private AS
numbers.
peer-group-
name
Enter the name of the peer group to remove the private AS
numbers.
420
Border Gateway Protocol