Administrator Guide

peer-group-
name
Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to
drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
NOTE: This command sends routes to peers only if an
outbound policy is configured and if there is a change in
the existing outbound policy.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
422
Border Gateway Protocol