Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
debug ipv6 dhcp
To enable debug logs for DHCPv6 relay agent transactions.
Syntax
debug ipv6 dhcp
To disable the debug logs for dhcpv6 relay agent transactions, use the debug
ipv6 dhcp command.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
default-router
Assign a default gateway to clients based on the address pool.
Z9000
Syntax
default-router address [address2...address8]
Parameters
address Enter a list of routers that may be the default gateway for
clients on the subnet. You may specify up to eight routers.
List them in order of preference.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Dynamic Host Configuration Protocol (DHCP)
541