Administrator Guide

Usage
Information
This command places you into the resilient ring protocol. After executing this
command, the command line prompt changes to conf-frrp.
show frrp
Display the resilient ring protocol configuration.
Z9000
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id Enter the ring identification number. The range is from 1 to
255
summary (OPTIONAL) Enter the keyword summary to view just a
summarized version of the Ring configuration.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage
Information
Executing this command without the optional ring-id command clears the
statistics counters on all the available rings. Dell Networking OS requires a
command line confirmation before the command executes. This command clears
the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Force10 Resilient Ring Protocol (FRRP)
605