Administrator Guide

When you configure a static SSM map and the router cannot find any matching
access lists, the router continues to accept (*,G) groups.
Related
Commands
ip access-list standard — creates a standard access list to filter based on IP address.
ip igmp static-group
Configure an IGMP static group.
Z9000
Syntax
ip igmp static-group {group address [exclude [source address]]
| [include {source address}]}
To delete a static address, use the no ip igmp static-group {group
address [exclude [source address]] | [include {source
address}]}
command.
Parameters
group address Enter the group address in dotted decimal format (A.B.C.D).
exclude source
address
(OPTIONAL) Enter the keyword exclude then the source
address, in dotted decimal format (A.B.C.D), for which a
static entry is added.
include source
address
(OPTIONAL) Enter the keyword include then the source
address, in dotted decimal format (A.B.C.D), for which a
static entry is added.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Expanded to support the exclude and include options.
Internet Group Management Protocol (IGMP)
637