Administrator Guide

Usage
Information
Dell Networking OS provides the capability of statically configuring the interface to
which a multicast router is attached. To configure a static connection to the
multicast router, enter the ip igmp snooping mrouter interface command
in the VLAN context. The interface to the router must be a part of the VLAN where
you are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp
snooping querier command.
Defaults Not configured.
Command
Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This
behavior is useful when there is no multicast router present in the VLAN because
the multicast traffic is not routed. Assign an IP address to the VLAN interface for the
switch to act as a querier for this VLAN.
Internet Group Management Protocol (IGMP)
651