Administrator Guide

Defaults flash memory
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
Include the colon (:) when entering this command.
CAUTION: This command deletes all files, including the startup
configuration file. So, after executing this command, consider saving the
running config as the startup config (use the write memory command or
copy run start command).
restore factory-defaults
Restore factory defaults.
Syntax
restore factory-defaults stack-unit {0-5 | all} {clear-all |
bootvar | nvram}
Parameters
factory-
defaults
Return the system to its factory default mode.
0-5 Enter the stack member unit identifier to restore only the
mentioned stack-unit.
all Enter the keyword all to restore all units in the stack.
bootvar Enter the keyword bootvar to reset boot line.
clear-all Enter the keywords clear-all to reset the NvRAM, boot
environment variables, and the system startup configuration.
nvram Enter the keyword nvram to reset the NvRAM only.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
File Management
71