Administrator Guide

duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with
the speed set to 10/100.
management route — configures a static route that points to the Management
interface or a forwarding router.
stack-unit portmode
You can split a single 40G port into four-10G ports.
Z9000
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member
to reset. For the Z9000, the range is from 0 to 7.
number Enter the port number of the 40G port to be split. The range
is from 0 to 124 in multiples of 4 (0, 4, 8, 12, ... 120 124).
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for dynamically fanning-out of interfaces on
S6000. Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage
Information
Splitting a 40G port into 4x10G port is supported on standalone and stacked units.
stack-unit stack-unit port number portmode quad dynamically fan-out
40G ports to 10G ports and vice-versa without reload in switch.
The quad port must be in a default configuration before it can be split into 4x10G
ports. The 40G port is lost in the config when the port is split, so be sure that the
port is also removed from other L2/L3 feature configurations.
The system must be reloaded after issuing the CLI for the change to take effect.
This command cannot be used if LR4 optics are inserted on the 40G interface.
720
Interfaces