Administrator Guide

application
Configure the management egress interface selection.
Z9000
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all | application-type} command.
Parameters
application-
type
Enter any of the following keywords:
• For DNS, enter the keyword dns.
• For FTP, enter the keyword ftp.
• For NTP, enter the keyword ntp.
• For Radius, enter the keyword radius.
• For sFlow collectors, enter the keyword sflow-
collector.
• For SNMP (traps and MIB responses), enter the keywords
snmp .
• For SSH, enter the keyword ssh .
• For Syslog, enter the keyword syslog.
• For TACACS, enter the keyword tacacs.
• For Telnet, enter the keyword telnet.
• For TFTP, enter the keyword tftp.
all Configure all applications.
Defaults None.
Command
Modes
EIS Mode (conf-mgmt-eis)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Interfaces
723