Administrator Guide

A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on
the first interface configured in the Port Channel and enabled, Dell Networking OS
determines if the Port Channel uses 100 Mb/s or 1000 Mb/s as the common speed.
For more information, refer to channel-member.
If the line card is in a Jumbo mode chassis, you can also configure the mtu and ip
mtu commands. The Link MTU and IP MTU values configured on the channel
members must be greater than the Link MTU and IP MTU values configured on the
Port Channel interface.
NOTE: In a Jumbo-enabled system, all members of a Port Channel must be
configured with the same link MTU values and the same IP MTU values.
Example
Dell(conf)#int port-channel 2
Dell(conf-if-po-2)#
Related
Commands
channel-member — adds a physical interface to the LAG.
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface null — configures a null interface.
interface vlan — configures a VLAN.
shutdown — disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the
LAG to be also in “oper up” status.
Z9000
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up”
status. The range is from 1 to 16. The default is 1.
Defaults 1
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
732
Interfaces