Administrator Guide

ip address Enter an IP address, in dotted decimal format, to be mapped
to the name.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
ip icmp source-interface
Enable the ICMP error and unreachable messages to be sent with the source interface IP address, such as
the loopback address, instead of the hops of the preceding devices along the network path to be used for
easy debugging and diagnosis of network disconnections and reachability problems with IPv4 packets.
Syntax
ip icmp source-interface interface
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a Management Ethernet interface, enter the keyword
managementethernet.
782
IPv4 Routing