Administrator Guide

Version Description
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet
interfaces. Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table.
Z9000
Syntax
show arp [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static |
dynamic] [inspection {database | statistics][summary]
Parameters
interface
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1. The port range
is 0.
IPv4 Routing
801