Administrator Guide

l2acl Set L2-ACL entries
Dell(conf)#cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
Dell(conf)#cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
cam-acl
Allocate space for IPv6 ACLs.
Z9000
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos
1-10 l2qos 1-10}
Parameters
default Use the default CAM profile settings, and set the CAM as
follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
l2acl 1-10
ipv4acl 1-10
ipv6acl 0-10
ipv4qos 1-10
l2qos 1-10
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount to
be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
IPv6 Access Control Lists (IPv6 ACLs)
845