Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
maximum dynamic-routes-ipv6
Specify the maximum number of dynamic (protocol) IPv6 routes a VRF can have.
Syntax maximum dynamic-routes—ipv6 limit {warn-threshold threshold-value
| warning-only}
To remove the limit on the maximum number of IPv6 routes used, use the no
maximum dynamic-routes-ipv6
command.
Parameters
limit Maximum number of IPv6 routes allowed in a VRF. Valid
range is from 1 to 8000 (or maximum allowable for that
platform if smaller value).
warning-
threshold
Warning threshold value is expressed as a percentage of the
limit value. When the number of IPv6 routes reaches the
specified percentage of the limit, a warning message is
generated. Valid range is 1 to 100. When warn-threshold is
used, once the limit is reached, additional routes will not be
allowed into the RTM ( route table manager ) itself.
warning-only When the warning-only option is used, a syslog message will
be thrown when maximum number of dynamic IPv6 routes
reaches the limit. Additional dynamic IPv6 routes will still be
allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command
Modes
CONFIGURATION-VRF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv6 Basics
849