Administrator Guide

isis hello padding
Turn ON or OFF padding of hello PDUs from INTERFACE mode.
Syntax
isis hello padding
To return to the default, use the no isis hello padding command.
Defaults Padding of hello PDUs is enabled (ON).
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage
Information
Hello PDUs are “padded” only when both the global and interface padding options
are ON. Turning either one OFF disables padding for the corresponding interface.
Related
Commands
hello padding — turns ON or OFF padding for LAN and point-to-point hello PDUs.
isis ipv6 metric
Assign metric to an interface for use with IPv6 information.
Syntax
isis ipv6 metric default-metric [level-1 | level-2]
To return to the default values, use the no ipv6 isis metric [default-
metric
] [level-1 | level-2] command.
Parameters
default-metric Metric assigned to the link and used to calculate the cost
from each other router via the links in the network to other
destinations. You can configure this metric for Level 1 or
Level 2 routing. The range is from 0 to 16777215. The default
is 10.
906
Intermediate System to Intermediate System (IS-IS)