Administrator Guide

Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number Enter a number as the maximum number of parallel paths an
IP routing installs in a routing table. The range is from 1 to 16.
The default is 4.
Defaults 4
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Added support for multi-topology ISIS.
6.3.1.0 Introduced.
metric-style
To generate and accept old-style, new-style, or both styles of type, length, and values (TLV), configure a
router.
Syntax
metric-style {narrow [transition] | transition | wide
[transition]} [level-1 | level-2]
To return to the default values, use the no metric-style {narrow
[transition] | transition | wide [transition]} [level-1 |
level-2] command.
Parameters
narrow Allows you to generate and accept old-style TLVs. The
metric range is from 0 to 63.
918
Intermediate System to Intermediate System (IS-IS)