Administrator Guide

The following describes the show mac-address-table count command shown
in the following example.
Line Beginning
With
Description
MAC Entries... Displays the number of MAC entries learned per VLAN.
Dynamic
Address...
Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Total MAC... Lists the total number of MAC addresses the switch uses.
Example
(Count)
Dell# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
Dell#
Related
Commands
show mac-address-table aging-time — displays MAC aging time.
show mac-address-table aging-time
Display the aging times assigned to the MAC addresses on the switch.
Z9000
Syntax
show mac-address-table aging-time [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to
display the MAC address assigned to the VLAN. The range is
from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Layer 2
973