Reference Guide

IPv4 Routing | 383
To view current bindings, use the show hosts command.
Figure 18-5. show hosts Command Example
To view the current configuration, use the show running-config resolve command.
Specify local system domain and a list of domains
If you enter a partial domain, FTOS can search different domains to finish or fully qualify that partial
domain. A fully qualified domain name (FQDN) is any name that is terminated with a period/dot. FTOS
searches the host table first to resolve the partial domain. The host table contains both statically configured
and dynamically learnt host and IP addresses. If FTOS cannot resolve the domain, it tries the domain name
assigned to the local system. If that does not resolve the partial domain, FTOS searches the list of domains
configured
To configure a domain name, use the following command in the CONFIGURATION mode:
To configure a list of domain names, use the following command in the CONFIGURATION mode:
Command Syntax Command Mode Purpose
ip domain-lookup
CONFIGURATION Enable dynamic resolution of host names.
ip name-server ip-address
[ip-address2 ... ip-address6]
CONFIGURATION Specify up to 6 name servers. The order you entered the
servers determines the order of their use.
Command Syntax Command Mode Purpose
ip domain-name name CONFIGURATION Enter up to 63 characters to configure one domain name
for the E-Series.
FTOS>show host
Default domain is force10networks.com
Name/address lookup uses domain service
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
patch1 (perm, OK) - IP 192.68.69.2
tomm-3 (perm, OK) - IP 192.68.99.2
gxr (perm, OK) - IP 192.71.18.2
f00-3 (perm, OK) - IP 192.71.23.1
FTOS>