Reference Guide

446 | Intermediate System to Intermediate System
www.dell.com | support.dell.com
For any level (Level-1, Level-2, or Level-1-2), the value range possible in the isis metric command in
INTERFACE mode changes depending on the metric style.
Maximum Values in the Routing Table
IS-IS metric styles support different cost ranges for the route. The cost range for the narrow metric style is
0 to 1023, while all other metric styles support a range of 0 to 0xFE000000.
Changing the IS-IS Metric Style in One Level Only
By default, the IS-IS metric style is narrow. When you change from one IS-IS metric style to another, the
IS-IS metric value (configured with the
isis metric command) could be affected.
In the following scenarios, the IS-type is either Level-1 or Level-2 or Level-1-2 and the metric style
changes.
Table 20-4. Correct Value Range for the isis metric Command
Metric Style Correct Value Range for the isis metric Command
wide 0 to 16777215
narrow 0 to 63
wide transition 0 to 16777215
narrow transition 0 to 63
transition 0 to 63
Table 20-5. Metric Value when Metric Style Changes
Beginning metric style Final metric style Resulting IS-IS metric value
wide narrow default value (10) if the original value is greater than
63.
A message is sent to the console.
wide transition truncated value
1
(the truncated value appears in the
LSP only.)
The original
isis metric value is displayed in the
show config and show running-config commands
and is used if you change back to transition metric
style.
wide narrow transition default value (10) if the original value is greater than
63.
A message is sent to the console.
wide wide transition original value
narrow wide original value
narrow transition original value
narrow narrow transition original value
narrow wide transition original value