Administrator Guide

3. Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
4. Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
The range is from 1 to 128.
5. Configure the IP address of the management interface on the remote VLT peer to be used as the
endpoint of the VLT backup link for sending out-of-band hello messages.
VLT DOMAIN CONFIGURATION mode
back-up destination ip-address [interval seconds]
You can optionally specify the time interval used to send hello messages. The range is from 1 to 5
seconds.
6. When you create a VLT domain on a switch, Dell Networking OS automatically creates a VLT-system
MAC address used for internal system operations.
VLT DOMAIN CONFIGURATION mode
system-mac mac-address mac-address
To explicitly configure the default MAC address for the domain by entering a new MAC address, use
the system-mac command. The format is aaaa.bbbb.cccc.
Also reconfigure the same MAC address on the VLT peer switch.
Use this command to minimize the time required for the VLT system to synchronize the default MAC
address of the VLT domain on both peer switches when one peer switch reboots.
7. When you create a VLT domain on a switch, Dell Networking OS automatically assigns a unique unit
ID (0 or 1) to each peer switch.
VLT DOMAIN CONFIGURATION mode
unit-id {0 | 1}
The unit IDs are used for internal system operations.
To explicitly configure the default values on each peer switch, use the unit-id command.
Configure a different unit ID (0 or 1) on each peer switch.
Use this command to minimize the time required for the VLT system to determine the unit ID
assigned to each peer switch when one peer switch reboots.
850
Virtual Link Trunking (VLT)