Reference Guide

Remote Monitoring (RMON) | 1003
rmon collection history
c e s z
Enable the RMON MIB history group of statistics collection on an interface.
Syntax
rmon collection history {controlEntry integer} [owner name] [buckets number] [interval
seconds]
To remove a specified RMON history group of statistics collection, use the no rmon collection
history {controlEntry integer} command.
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION INTERFACE (config-if)
Command
History
rmon collection statistics
c e s z
Enable RMON MIB statistics collection on an interface.
Syntax
rmon collection statistics {controlEntry integer} [owner name]
To remove RMON MIB statistics collection on an interface, use the no rmon collection statistics
{controlEntry integer} command.
Version 7.5.1.0 Support added for C-Series
Version 6.1.1.0 Introduced for E-Series
controlEntry integer Enter the keyword controlEntry to specify the RMON group of statistics
using a value. Then enter an integer value from 1 to 65535 that identifies the
RMON group of statistics. The integer value must be a unique index in the
RMON History Table.
owner name
(OPTIONAL) Enter the keyword owner followed by the owner name to
record the owner of the RMON group of statistics.
buckets number
(OPTIONAL) Enter the keyword buckets followed the number of buckets
for the RMON collection history group of statistics.
Bucket Range: 1 to 1000
Default: 50
interval seconds
(OPTIONAL) Enter the keyword interval followed the number of seconds
in each polling cycle.
Range: 5 to 3600 seconds
Default: 1800 seconds
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.1.1.0 Introduced for E-Series