Reference Guide

1022 | Rapid Spanning Tree Protocol (RSTP)
www.dell.com | support.dell.com
Example
Figure 36-6. spanning-tree rstp edge-port Command
tc-flush-standard
c e s z
Enable the MAC address flushing upon receiving every topology change notification.
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
By default FTOS implements an optimized flush mechanism for RSTP. This helps in flushing MAC
addresses only when necessary (and less often), allowing for faster convergence during topology
changes. However, if a standards-based flush mechanism is needed, this knob command can be turned
on to enable flushing MAC addresses upon receiving every topology change notification.
FTOS(conf)#interface gigabitethernet 4/0
FTOS(conf-if-gi-4/0)#spanning-tree rstp edge-port
FTOS(conf-if-gi-4/0)#show config
!
interface GigabitEthernet 4/0
no ip address
switchport
spanning-tree rstp edge-port
no shutdown
FTOS#
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.5.1.0 Introduced for E-Series