Reference Guide

Security | 1029
privilege level (CONFIGURATION mode)
c e s z
Change the access or privilege level of one or more commands.
Syntax
privilege mode {level level command | reset command}
To delete access to a level and command, use the no privilege mode level level command command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Usage Information
Use the enable password command to define a password for the level to which you are assigning
privilege or access.
Version 7.5.1.0 Introduced for C-Series
Version 6.1.1.0 Added support for RADIUS
mode
Enter one of the following keywords as the mode for which you are controlling access:
•
configure for the CONFIGURATION mode
•
exec for the EXEC mode
•
interface for the INTERFACE modes
•
line for the LINE mode
•
route-map for the ROUTE-MAP
•
router for the ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER BGP
modes.
level level Enter the keyword level followed by a number for the access level.
Range: 0 to 15
Level 1 is the EXEC mode and Level 15 allows access to all CLI modes and commands.
reset Enter the keyword reset to return the security level to the default setting.
command
Enter the command’s keywords to assign the command to a certain access level. You can
enter one or all of the keywords
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.1.1.0 Introduced for E-Series