Reference Guide

1086 | sFlow
www.dell.com | support.dell.com
sflow enable (Interface)
c e s z
Enable sFlow on Interfaces.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults
sFlow is disabled by default on all interfaces
Command Modes
INTERFACE
Command
History
Usage
Information
When sFlow is enable on an interface, flow sampling is done on any traffic going out of the interface.
Related
Commands
sflow extended-gateway enable
e
Enable packing information on an extended gateway.
Syntax
sflow extended-gateway [extended-router] [extended-switch] enable
To disable packing information, use the no sflow extended-gateway [extended-router]
[extended-switch] enable command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Version 8.3.11.1 Introduced on Z9000
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
Note: Once a physical port is a member of a LAG, it will inherit the sFlow configuration
from the LAG port.
sflow enable (Global) Turn sFlow on globally
extended-router Enter the keyword extended-router to collect extended router
information.
extended-switch Enter the keyword extended-switch to collect extended switch
information.
enable Enter the keyword enable to enable global extended information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series