Reference Guide

Simple Network Management Protocol and Syslog | 1109
Related
Commands
snmp-server view
c e s z
Configure an SNMPv3 view.
Syntax
snmp-server view view-name oid-tree {included | excluded}
To remove an SNMPv3 view, use the no snmp-server view view-name oid-tree {included |
excluded} command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
The oid-tree variable is a full sub-tree starting from 1.3.6 and can not specify the name of a sub-tree or
a MIB. The following example configures a view named rview that allows access to all objects under
1.3.6.1:
Example
Figure 40-10. snmp-server view Command Example
Related
Commands
Note: The number of configurable users is limited to 16.
FTOS#conf
FTOS(conf)# snmp-server user n3user ngroup remote 172.31.1.3 udp-port 5009 3 auth
md5 authpasswd
show snmp user
Display the information configured on each SNMP user name.
view-name
Enter the name of the view (not to exceed 20 characters).
oid-tree
Enter the OID sub tree for the view (not to exceed 20 characters).
included (OPTIONAL) Enter the keyword included to include the MIB family in
the view.
excluded (OPTIONAL) Enter the keyword excluded to exclude the MIB family in
the view.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
FTOS# conf
FTOS#(conf) snmp-server view rview 1.3.6.1 included
show running-config snmp Display the SNMP running configuration