Reference Guide

1110 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
snmp trap link-status
c e s z
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, enter no snmp trap link-status.
Defaults
Enabled.
Command Modes
INTERFACE
Command
History
Usage
Information
If the interface is expected to flap during normal usage, you could disable this command.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Force10 switches:
• clear logging
• default logging buffered
• default logging console
• default logging monitor
• default logging trap
• logging
• logging buffered
• logging console
• logging facility
• logging history
• logging history size
• logging monitor
• logging on
• logging source-interface
• logging synchronous
• logging trap
• show logging
• show logging driverlog stack-unit (S-Series)
• terminal monitor
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command