Reference Guide

1162 | VLAN Stacking
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Mode
CONF-IF-VLAN
Command
History
Usage
Information
You must enable the Stackable VLAN (using the vlan-stack compatible command) on the VLAN prior
to adding a member to the VLAN.
Related
Commands
show interface dei-honor
c s
Display the dei honor configuration.
Syntax
show interface dei-honor [interface slot/port | linecard number port-set number]
Parameters
Command Mode
EXEC Privilege
Command
History
Example
FTOS#show interface dei-honor
Default Drop precedence: Green
Interface CFI/DEI Drop precedence
-------------------------------------------------------------
Gi 0/1 0 Green
Gi 0/1 1 Yellow
Gi 8/9 1 Red
Gi 8/40 0 Yellow
Related
Commands
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number from 1 to 32
for EtherScale, 1 to 255 for TeraScale and ExaScale; 1 to 128 for C-Series and S-Series.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
Version 8.3.11.1 Introduced on Z9000
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.6.1.0 Support added for C-Series and S-Series
E-Series original Command
vlan-stack compatible Enable Stackable VLAN on a VLAN.
interface slot/port Enter the interface type followed by the line card slot and port
number.
linecard number port-set
number
Enter linecard followed by the line card slot number, then enter port-set
followed by the port-pipe number.
Version 8.3.1.0 Introduced on C-Series and S-Series.
dei honor
Honor the incoming DEI value by mapping it to an FTOS drop
precedence.