Reference Guide

1176 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
priority
c e s z
Specify a VRRP priority value for the VRRP group. This value is used by the VRRP protocol during
the MASTER election process.
Syntax
priority priority
To return to the default value, enter no priority.
Parameters
Defaults
100
Command Modes
VRRP
Command
History
Usage
Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual address with
same IP address as the interface’s primary IP address and change the priority of the VRRP group to
255.
If you set the priority to 255 and the virtual-address is not equal to the interface’s primary IP address,
an error message appears.
show config
c e s z
View the non-default VRRP configuration.
Syntax
show config [verbose]
Parameters
Command Modes
VRRP
Command
History
priority
Enter a number as the priority. Enter 255 only if the router’s virtual address is the same as
the interface’s primary IP address (that is, the router is the OWNER).
Range: 1 to 255.
Default: 100.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group configuration
information, including defaults.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series