Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1177
Example
Figure 45-1. show config Command Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
c e s z
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active
VRRP group
.”
Syntax
show vrrp [vrrp-id] [interface] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 45-2. show vrrp brief Command Example
vrrp-id
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view only that
group.
Range: 1 to 255.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
For Port Channel interface types, enter the keyword
port-channel followed by the
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale
For SONET interfaces, enter the keyword
sonet followed by the slot/port
information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
For a VLAN interface, enter the keyword
vlan followed by the VLAN ID. The
VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups on the E-Series.
Version 8.3.11.1 Introduced on Z9000
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
FTOS>Interface Grp Pri Pre State Master addr Virtual addr(s)
Description------------------------------------------------------------------------------
Gi 10/37 1 100 Y Master 200.200.200.200 200.200.200.201
Gi 10/37 2 100 Y Master 200.200.200.200 200.200.200.202 200.200.200.203 Description
Gi 10/37 3 100 Y Master 1.1.1.1 1.1.1.2
Gi 10/37 4 100 Y Master 200.200.200.200 200.200.200.206 200.200.200.207 ... short desc
Gi 10/37 254 254 Y Master 200.200.200.200 200.200.200.204 200.200.200.205
FTOS>