Reference Guide

1178 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Figure 45-3. Command Example: show vrrp
Table 45-1. Command Example Descriptions: show vrrp brief
Item Description
Interface Lists the interface type, slot and port on which the VRRP group is
configured.
Grp Displays the VRRP group ID.
Pri Displays the priority value assigned to the interface.
If the track command is configured to track that interface and the interface
is disabled, the
cost is subtracted from the priority value assigned to the
interface.
Pre States whether preempt is enabled on the interface.
• Y = Preempt is enabled.
• N = Preempt is not enabled.
State Displays the operational state of the interface by using one of the
following:
• NA/IF (the interface is not available).
• MASTER (the interface associated with the MASTER router).
• BACKUP (the interface associated with the BACKUP router).
Master addr Displays the IP address of the MASTER router.
Virtual addr(s) Displays the virtual IP addresses of the VRRP routers associated with the
interface.
FTOS>show vrrp
------------------
GigabitEthernet 12/3, VRID: 1, Net: 10.1.1.253
State: Master, Priority: 105, Master: 10.1.1.253 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.252
Authentication: (none)
Tracking states for 1 interfaces:
Up GigabitEthernet 12/17 priority-cost 10
------------------
GigabitEthernet 12/4, VRID: 2, Net: 10.1.2.253
State: Master, Priority: 110, Master: 10.1.2.253 (local)
Hold Down: 10 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:02
Virtual IP address:
10.1.2.252
Authentication: (none)
Tracking states for 2 interfaces:
Up GigabitEthernet 2/1 priority-cost 10
Up GigabitEthernet 12/17 priority-cost 10
FTOS>