Reference Guide

1196 | Z-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Defaults
Enabled
Command Mode
CONFIGURATION
Command History
Usage Information
This command enables a hardware watchdog mechanism that automatically reboots an FTOS switch/
router with a single unresponsive unit. This is a last resort mechanism intended to prevent a manual
power cycle.
show hardware layer2
s z
Display Layer 2 ACL or eg data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer2 {eg-acl | in-acl} stack-unit id port-set 0-3
Parameters
Defaults
No default behavior
Command Modes
EXEC Privilege
Command History
Usage Information
The unit numbers given are internal port numbers. For a cross reference of the internal and user port
numbers, see the Z9000 Debugging and Diagnostics chapter in the FTOS Configuration Guide for the
Z9000 System.
show hardware layer3
s z
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer3 {eg-acl | in-acl | qos} stack-unit id port-set 0-3
Parameters
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to select between
ingress or egress ACL data.
stack-unit id Enter the keyword stack-unit to select a stack ID.
Unit ID range:
Z9000: 0
port-set 0-3 Enter the keyword port-set with a port-pipe number — 0 or 3. The S25 models of the
S-Series have only port-pipe 0.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on S-Series
eg-acl | in-acl | qos Enter either the keyword eg-acl, in-acl or qos to select between
ACL or QoS data.