Reference Guide

122 | Control and Monitoring
www.dell.com | support.dell.com
show processes ipc flow-control
c e s z
Display the Single Window Protocol Queue (SWPQ) statistics.
Syntax
show processes ipc flow-control [cp | rp1 | rp2 | lp linecard-number]
Parameters
* In the S-Series, this command supports only the cp keyword, not the rp1, rp2, and lp
options. See
Figure 4-42.
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
Figure 4-38. Command Example: show processes ipc flow-control from
show hardware stack-unit Display the data plane or management plane input and output
statistics of the designated component of the designated stack
member.
show hardware system-flow Display Layer 3 ACL or QoS data for the selected stack member
and stack member port-pipe.
show interfaces stack-unit Display information on all interfaces on a specific S-Series stack
member.
show processes memory
(S-Series)
Display CPU usage information based on processes running in an
S-Series
cp (OPTIONAL) Enter the keyword cp to view the Control Processor’s SWPQ
statistics.
rp1 (OPTIONAL) Enter the keyword rp1 to view the Control Processor’s SWPQ
statistics on Route Processor 1.*
rp2 (OPTIONAL) Enter the keyword rp2 to view the Control Processor’s SWPQ
statistics on Route Processor 2.*
lp linecard-number (OPTIONAL) Enter the keyword lp followed by the line card number to
view the Control Processor’s SWPQ statistics on the specified line card.*
Version 8.3.11.1 Introduced on the Z9000
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series