Reference Guide

196 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
source
Enter the IP address of the network or host from which the packets were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host followed by the IP address to specify a host IP address.
dscp
Enter this keyword to deny a packet based on DSCP value.
Range: 0-63
operator
(OPTIONAL) Enter one of the following logical operand:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt = less than
•
range = inclusive range of ports
port port
(OPTIONAL) Enter the application layer port number. Enter two port numbers if
using the
range logical operand.
Range: 0 to 65535
destination
Enter the IP address of the network or host to which the packets are sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log.
Supported on Jumbo-enabled line cards only.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry.
Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower order
numbers have a higher priority)
Default: If the order keyword is not used, the ACLs have the lowest order by
default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule will be
applied to the monitored interface. For details, see the section “Flow-based
Monitoring” in the Port Monitoring chapter of the FTOS Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet fragments.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0
Added
dscp keyword.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series