Reference Guide

20 | CLI Basics
www.dell.com | support.dell.com
LINE Mode
Use the LINE mode to configure console or virtual terminal parameters.
To enter LINE mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Enter the line command. You must include the keywords console or vty and their line number
available on the switch.The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the exit command.
TRACE-LIST Mode
When in the CONFIGURATION mode, use the trace-list command to enter the TRACE-LIST mode
and configure a Trace list.
1. Verify that you are logged in to the CONFIGURATION mode.
2. Enter the ip trace-list command. You must include the name of the Trace list. The prompt change
to include (conf-trace-acl).
You can exit this mode by using the exit command.
MAC ACCESS LIST Mode
While in the CONFIGURATION mode, use the mac access-list standard or mac access-list
extended command to enter the MAC ACCESS LIST mode and configure either standard or extended
access control lists (ACL).
To enter MAC ACCESS LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Use the mac access-list standard or mac access-list extended command. You must include a
name for the ACL.The prompt changes to include (conf-std-macl) or (conf-ext-macl).
You can return to the CONFIGURATION mode by entering the exit command.
FTOS(conf-if-lo-0)# Loopback interface number
FTOS(conf-if-nu-0)# Null interface followed by zero
FTOS(conf-if-po-0)# Port-channel interface number
FTOS(conf-if-vl-0)# VLAN interface followed by VLAN number (range 1 to 4094)
FTOS(conf-if-so-0/0)# SONET interface followed by slot/port information.
FTOS(conf-if-ma-0/0)# Management Ethernet interface followed by slot/port information
FTOS(conf-if-range)# Designated interface range (used for bulk configuration; see interface range).
Table 2-3. Interface prompts
Prompt Interface Type