Reference Guide

222 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
Usage
Information
When you use the log option, CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
Related
Commands
seq
c e s z
Assign a sequence number to a deny or permit filter in a MAC access list while creating the filter.
Syntax
seq sequence-number {deny | permit} {any | mac-source-address
[mac-source-address-mask]} [count [byte]] [log] [monitor]
To remove this filter, use the no seq sequence-number command.
Parameters
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in which
you are creating the rule will be applied to the monitored interface.
For details, see the section “Flow-based Monitoring” in the Port
Monitoring chapter of the FTOS Configuration Guide.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Note: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
deny Configure a MAC ACL filter to drop packets.
seq Configure a MAC ACL filter with a specified sequence number.
sequence-number
Enter a number between 0 and 65535.
deny Enter the keyword deny to configure a filter to drop packets meeting
this condition.
permit Enter the keyword permit to configure a filter to forward packets
meeting this criteria.
any Enter the keyword any to filter all packets.
mac-source-address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.