Reference Guide

238 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match interface
c e s z
Configure a filter to match routes whose next hop is on the interface specified.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
community-list-name
Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords exact to process only those routes with this
community list name.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
ip community-list Configure an Community Access list.
set community Specify a COMMUNITY attribute.
neighbor send-community Send COMMUNITY attribute to peer or peer group.
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port
information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/
port information.
• For the loopback interface, enter the keyword
loopback followed by a number from zero (0)
to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094, 1-2094 for
ExaScale (can used IDs 1-4094).
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port
information.