Reference Guide

Access Control Lists (ACL) | 253
show route-map
c e s z
Display the current route map configurations.
Syntax
show route-map [map-name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 6-14. Command Example: show route-map
Related
Commands
AS-Path Commands
This feature is supported on E-Series only, as indicated by this character under each command
heading: e
The following commands configure AS-Path ACLs.
• deny
• ip as-path access-list
• permit
• show config
• show ip as-path-access-lists
map-name
(OPTIONAL) Enter the name of a configured route map, up to 140 characters.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
FTOS#show route-map
route-map firpo, permit, sequence 10
Match clauses:
Set clauses:
tag 34
FTOS#
route-map Configure a route map.