Reference Guide

324 | Border Gateway Protocol
www.dell.com | support.dell.com
Related
Commands
Command
History
neighbor soft-reconfiguration inbound
c e s z
Enable soft-reconfiguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
command.
Parameters
Defaults
Disabled
Command Modes
ROUTER BGP
Usage
Information
This command enables soft-reconfiguration for the BGP neighbor specified. BGP will store all the
updates received by the neighbor but will not reset the peer-session.
Related
Commands
Command
History
show ip bgp summary Displays the current BGP configuration.
show ip bgp neighbors Displays the current BGP neighbors.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to disable or enable all routers within the
peer group.
Caution: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results
applied on the neighbor.
Note: This command is supported in BGP Router Configuration mode for IPv4 Unicast
address only.
show ip bgp neighbors Display routes received by a neighbor
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.4.1.0 Introduced