Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 Z9000

381

382

383

384

385

386

387

388

389

390

388 | Border Gateway Protocol

www.dell.com | support.dell.com

Parameters

Defaults

No default values or behavior

Command Modes

ROUTE MAP (config-route-map)

Usage

Information

If the set community rt and soo are in the same route-map entry, we can define the behavior as:

• If rt option comes before soo, with or without additive option, then soo overrides the

communities set by rt

• If rt options comes after soo, without the additive option, then rt overrides the communities set by

soo

• If rt with additive option comes after soo, then rt adds the communities set by soo

Commands

Command

History

set extcommunity soo

c e s z

Use this feature to set extended community site-of-origin in Route Map.

Syntax

set extcommunity soo {as4 ASN4:NN | ASN:NNNN | IPADDR:NN [non-trans]}

To delete the site-of-origin community, use the no set extcommunity command.

Parameters

Defaults

No default behavior or values

as4 ASN4:NN Enter the keyword as4 followed by the 4-octet AS specific extended community

number in the format ASN4:NN (4-byte AS number:2-byte community value)

ASN:NNNN

Enter the 2-octet AS specific extended community number in the format

ASN:NNNN (2-byte AS number:4-byte community value)

IPADDR:NN

Enter the IP address specific extended community in the format IPADDR:NN (4-byte

IPv4 Unicast Address:2-byte community value)

additive (OPTIONAL) Enter the keyword additive to add to the existing extended

community.

non-trans (OPTIONAL) Enter the keyword non-trans to indicate a non-transitive BGP

extended community.

set extcommunity soo Set extended community site-of-origin in route-map.

Version 7.8.1.0 Introduced on S-Series

Version 7.7.1.0 Introduced on C-Series

Version 7.6.1.0 Introduced on E-Series