Reference Guide

40 | File Management
www.dell.com | support.dell.com
show bootvar
c e z
Display the variable settings for the system boot parameters.
Syntax
show bootvar
Command Modes
EXEC Privilege
Command
History
Example
Figure 3-3. Command Output example: show bootvar
Related
Commands
show file
c e s z
Display contents of a text file in the local filesystem.
Syntax
show file filesystem
Parameters
Command Modes
EXEC Privilege
Version 8.3.11.4 Output expanded to display current reload mode (normal or Jumpstart).
Version 8.3.11.1 Introduced on the Z9000
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
FTOS#show bootvar
PRIMARY IMAGE FILE = ftp://box:password@10.31.1.205//home/5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin
SECONDARY IMAGE FILE = variable does not exist
DEFAULT IMAGE FILE = flash://FTOS-ED-5.3.1.0.bin
LOCAL CONFIG FILE = variable does not exist
PRIMARY HOST CONFIG FILE = variable does not exist
SECONDARY HOST CONFIG FILE = variable does not exist
PRIMARY NETWORK CONFIG FILE = variable does not exist
SECONDARY NETWORK CONFIG FILE = variable does not exist
CURRENT IMAGE FILE = ftp://box:password@10.31.1.205//home/5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin
CURRENT CONFIG FILE 1 = flash://startup-config
CURRENT CONFIG FILE 2 = variable does not exist
CONFIG LOAD PREFERENCE = local first
BOOT INTERFACE GATEWAY IP ADDRESS = variable does not exist
RELOAD MODE = normal-reload
FTOS#
boot config Set the location of configuration files on local devices.
boot host Set the location of configuration files from the remote host.
boot network Set the location of configuration files from a remote network.
boot system (S4810 and
Z9000)
Set the location of FTOS image files.
boot system gateway Specify the IP address of the default next-hop gateway for the management subnet.
filesystem
Enter one of the following:
•
flash: for the internal Flash
•
slot0: for the external Flash (C-Series, E-Series, Z9000)
•
usbflash: for the usbflash (C-Series, E-Series, S55, S60, Z9000 only)