Reference Guide

Border Gateway Protocol | 425
neighbor peer-group (creating group)
c e
Allows you to create a peer group and assign it a name.
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
Usage
Information
When a peer group is created, it is disabled (shut mode).
Related
Commands
neighbor peer-group passive
c e
Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message,
but will respond to one.
Syntax
neighbor peer-group-name peer-group passive
To delete a passive peer-group, use the no neighbor peer-group-name peer-group passive
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
Usage
Information
After you configure a peer group as passive, you must assign it a subnet using the neighbor subnet
command.
Related
Commands
peer-group-name
Enter a text string up to 16 characters long as the name of the peer group.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced
neighbor peer-group (assigning peers) Assign routers to a peer group.
neighbor remote-as Assign a indirectly connected AS to a neighbor or peer group.
neighbor shutdown Disable a peer or peer group.
peer-group-name
Enter a text string up to 16 characters long as the name of the peer group.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced
neighbor subnet Assign a subnet to a dynamically-configured BGP neighbor.