Reference Guide

Border Gateway Protocol | 435
redistribute ospf
e
Redistribute OSPFv3 routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
When you enter redistribute ospf process-id command without any other parameters, FTOS
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes.
router bgp
c e
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
process-id
Enter the number of the OSPFv3 process.
Range: 1 to 65535
match external
{
1 | 2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF external routes.
You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPFv3 internal
routes only.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced
as-number
Enter the AS number.
Range: 1 to 65535.