Reference Guide

Border Gateway Protocol | 459
network
e
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address [route-map map-name]
To remove a network, use the no network ipv6-address [route-map map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The E-Series software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable via non-BGP routes and
non-default routes.
Related
Commands
redistribute
e
Redistribute routes into BGP.
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static] [route-map map-name]
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 7.4.1.0 Introduced
redistribute Redistribute routes into BGP.
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.