Reference Guide

476 | Bare Metal Provisioning
www.dell.com | support.dell.com
stop jump-start
z
Stop the switch from reloading in Jumpstart (BMP) mode to prevent an infinite loop.
Syntax
stop jump-start
Defaults
None
Command Modes
EXEC Privilege
Command
History
Related
Commands
Usage
Information
Use the stop jump-start command on a switch running BMP 2.0 if the switch enters
a loop while reloading in jumpstart (BMP) mode; loop occurs when the switch is
continuously trying to contact a DHCP server and a DHCP server is not found. The
stop jump-start command stops the switch from connecting to the DHCP server.
After the
stop jump-start command is used, the next default reload type will be a
Normal reload. This will be indicated in the
show reload-type command.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.1 Introduced on S4810.
reload-type Configure the reload mode as Normal or jumpstart.