Reference Guide

Content Addressable Memory (CAM) | 481
Usage
Information
You must save the running configuration using the command copy running-config startup-config after
changing the CAM profile from CONFIGURATION mode. CAM profile changes take effect after the
next chassis reboot.
show cam-acl
c z
Display the details of the CAM profiles on the chassis and all line cards.
Syntax
show cam-acl
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Example
Figure 10-1. Command Output: show cam-acl (default)
Version 7.4.2.0 Added the unified-default CAM profile and lag-hash-align microcode
Version 7.4.1.0 Added the lag-hash-mpls microcode
Version 6.5.1.0 Added the eg-default and ipv4-320k CAM profiles
Version 6.3.1.0 Introduced on E-Series
Note: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
Note: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes lead to
unexpected behavior. After you reload the chassis, you may make changes to the IPv4 Flow
partition.
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series
FTOS#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 5
Ipv4Acl : 6
Ipv6Acl : 0
Ipv4Qos : 1
L2Qos : 1
-- Line card 4 --
Current Settings(in block sizes)
L2Acl : 5
Ipv4Acl : 6
Ipv6Acl : 0
Ipv4Qos : 1
L2Qos : 1
FTOS#