Reference Guide

498 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
Default
None
Command History
excluded-address
c s z
Prevent the server from leasing an address or range of addresses in the pool.
Syntax
excluded-address [address | low-address high-address]
Parameters
Command Mode
DHCP
Default
None
Command History
hardware-address
c s z
For manual configurations, specify the client hardware address.
Syntax
hardware-address address
Parameters
Command Mode
DHCP <POOL>
Default
None
Command History
host
c s z
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host address
Parameters
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on C-Series and S-Series.
address
Enter a single address to be excluded from the pool.
low-address
Enter the lowest address in a range of addresses to be excluded from the pool.
high-address
Enter the highest address in a range of addresses to be excluded from the pool.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on C-Series and S-Series.
address
Enter the hardware address of the client.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on C-Series and S-Series.
address/mask
Enter the host IP address and subnet mask.