Reference Guide

536 | GARP VLAN Registration (GVRP)
www.dell.com | support.dell.com
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
disable
c e s z
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults
Enabled
Command Modes
CONFIGURATION-GVRP
Command
History
Related
Commands
garp timers
c e s z
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave | leave-all} command.
event
Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu followed one of the following Interface keywords and slot/port
or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by the
Port Channel number:
C-Series and S-Series Range: 1-128
E-Series Range: 1-32 for EtherScale, 1-255 for TeraScale
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on C, E, and S-Series
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on C, E, and S-Series
gvrp enable Enable GVRP on physical interfaces and LAGs.
protocol gvrp Access GVRP protocol