Reference Guide

548 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
ip igmp query-interval
c e s z
Change the transmission frequency of IGMP general queries sent by the Querier.
Syntax
ip igmp query-interval seconds
To return to the default values, enter no ip igmp query-interval.
Parameters
Defaults
60 seconds
Command Modes
INTERFACE
Command
History
ip igmp query-max-resp-time
c e s z
Set the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, enter no ip igmp query-max-resp-time.
Parameters
Defaults
10 seconds
Command Modes
INTERFACE
Command
History
seconds
Enter the number of seconds between queries sent out.
Default: 60 seconds
Range: 1 to 18000
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to act as an
IGMP Proxy Querier.
Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to act as an
IGMP Proxy Querier.
E-Series legacy command
seconds
Enter the number of seconds for the maximum response time.
Default: 10 seconds
Range: 1 to 25
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to act as an
IGMP Proxy Querier.