Dell Force10 Z9000 : Reference Guide : Page 56

56 | File Management

www.dell.com | support.dell.com

Defaults

No configuration or default values

Command Modes

EXEC Privilege

Command

History

Usage

Information

RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) should be enclosed

in square brackets, [X:X:X:X::X]. For maximum flexibility this command will accept IPv6 host

addresses with or without the square brackets.

You must reload FTOS after executing this command. Use the command upgrade system stack-unit

(S-Series stack member) on page 242 to copy FTOS from the management unit to one or more stack

members.

upgrade fpga-image

e z

This command can only be used on systems with SFM3 modules (and only when required by the

upgrade procedure in the release notes). Upgrade the FPGA version in the specified E-Series SFM3

and automatically initiate an automatic reset to complete the version upgrade.

Syntax

upgrade fpga-image {sfm} {all | id} [booted | flash:// | ftp: |slot0: | tftp] file-url

Parameters

Version 9.0.0.0 Added support for IPv6 for file-url parameter

Version 8.3.11.1 Introduced on the Z9000, adding support for the SSD on the Z9000 only

Version 7.7.1.0 Added support for TFTP and SCP.

Version 7.6.1.0 Introduced on S-Series

FTOS# upgrade system ?

ftp: Copy from remote file system (ftp://userid:password@hostip/filepath)

scp: Copy from remote file system (scp://userid:password@hostip/filepath)

tftp: Copy from remote file system (tftp://hostip/filepath)

FTOS# upgrade system ftp://username:password@10.11.1.1/FTOS-SB-7.7.1.0.bin

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!

Erasing Sseries ImageUpgrade Table of Contents, please wait

.!..................................................................................................

....................................................................................................

....................................!

12946259 bytes successfully copied

FTOS# reload

sfm Enter the keyword sfm to upgrade the FPGA on the SFMs.

rpm Enter the keyword rpm to upgrade all processors on the RPM.

all Enter the keyword all to upgrade the FPGA on all the SFMs.

id Enter the keyword id to upgrade the FPGA on all a specific SFM.