Reference Guide

File Management | 57
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
Example
Figure 3-14. Command example: upgrade sfm autoreset
Related
Commands
0Usage
Information
On E-Series ExaScale, you cannot upgrade SFMs using this command when Cache Boot is configured.
If you attempt an upgrade, you must reload the chassis to recover.
Upgrading the C-Series FPGA
These commands are for upgrading the FPGA for C-Series RPMs and line cards.
• restore fpga-imagee
• upgrade fpga-image
Enter the path to the upgrade source. Entering <CR> updates the FPGA from the flash.
file-url
Enter the following location keywords and information to upgrade using an FTOS image
other than the one currently running:
• To specify an FTOS image on the internal flash, enter:
• flash:// file-path/filename.
• To specify an FTOS image on an FTP server, enter:
• ftp://user:password@hostip/filepath
• To specify an FTOS image on the external flash on the primary RPM, enter:
• slot0://file-path/filename
• To copy a file on a TFTP server, enter:
• tftp://hostip/filepath/filename
where hostip is either an IPv4 dotted decimal address or an IPv6 URI [x:x:x:x::x]
format address.
Version 9.0.0.0 Introduced on Z-Series
Version 8.3.1.0
Added
rpm option
Version 7.5.1.0 Introduced on E-Series
FTOS#upgrade sfm 1 autoreset
SFM1: upgrade in progress
!!! !!! !!!
SFM1: upgrade complete
SFM1 is active. Resetting it might temporarily impact traffic.
Proceed with reset [confirm yes/no]: yes
FTOS#
show sfm Display the SFM status.
upgrade (E-Series version)
Upgrade the E-Series.